ATMEGA169P-16MCHR【PDF 39/274 页】MCU AVR 16KB FLASH 16MHZ 64-VQFN

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3753

35页 36页 37页 38页 [39页]40页 41页 42页 43页

133

8018P–AVR–08/10

ATmega169P

15.11.7

ICR1H and ICR1L – Input Capture Register 1

The Input Capture is updated with the counter (TCNT1) value each time an event occurs on the

ICP1 pin (or optionally on the Analog Comparator output for Timer/Counter1). The Input Capture

can be used for defining the counter TOP value.

The Input Capture Register is 16-bit in size. To ensure that both the high and low bytes are read

simultaneously when the CPU accesses these registers, the access is performed using an 8-bit

temporary High Byte Register (TEMP). This temporary register is shared by all the other 16-bit

registers. See ”Accessing 16-bit Registers” on page 109.

15.11.8

TIMSK1 – Timer/Counter1 Interrupt Mask Register

Bit 5 – ICIE1: Timer/Counter1, Input Capture Interrupt Enable

When this bit is written to one, and the I-flag in the Status Register is set (interrupts globally

enabled), the Timer/Counter1 Input Capture interrupt is enabled. The corresponding Interrupt

Vector (See ”Interrupts” on page 56.) is executed when the ICF1 Flag, located in TIFR1, is set.

Bit 2 – OCIE1B: Timer/Counter1, Output Compare B Match Interrupt Enable

When this bit is written to one, and the I-flag in the Status Register is set (interrupts globally

enabled), the Timer/Counter1 Output Compare B Match interrupt is enabled. The corresponding

Interrupt Vector (See ”Interrupts” on page 56.) is executed when the OCF1B Flag, located in

TIFR1, is set.

Bit 1 – OCIE1A: Timer/Counter1, Output Compare A Match Interrupt Enable

When this bit is written to one, and the I-flag in the Status Register is set (interrupts globally

enabled), the Timer/Counter1 Output Compare A Match interrupt is enabled. The corresponding

Interrupt Vector (See ”Interrupts” on page 56.) is executed when the OCF1A Flag, located in

TIFR1, is set.

Bit 0 – TOIE1: Timer/Counter1, Overflow Interrupt Enable

When this bit is written to one, and the I-flag in the Status Register is set (interrupts globally

enabled), the Timer/Counter1 Overflow interrupt is enabled. The corresponding Interrupt Vector

(See ”Interrupts” on page 56.) is executed when the TOV1 Flag, located in TIFR1, is set.

Bit

765

432

(0x87)

ICR1[15:8]

ICR1H

(0x86)

ICR1[7:0]

ICR1L

Read/Write

R/W

Initial Value

Bit

765

(0x6F)

–

–ICIE1

–

OCIE1B

OCIE1A

TOIE1

TIMSK1

Read/Write

R/W

Initial Value

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式